\chapter{Introduction}

This is where the information goes. You can just write your work
here in a text editor like Wordpad or Notepad. Personally, I've
found WinEdt good but you will need to buy a licence for it.

If you want to add a picture, add the following text and figure will
then appear.

\begin{figure}
\centerline{\includegraphics[width=0.9\textwidth]{expres40.eps}}
\caption{\label{fig:1} Experimental Results of flow around a
circular cylinder at $Re_D=40$}
\end{figure}

If you want to add an equation, add the following text and the
equation will appear.

\begin{equation}
C_{X1}=\frac{(y_O - y_G)x_{OX2}}{x_{OX1} y_{OX2} - x_{OX2} y_{OX1}}
- \frac{(x_O - x_G)y_{OX2}}{x_{OX1} y_{OX2} - x_{OX2} y_{OX1}}
\label{Eq:1}
\end{equation}

For a table, put in the following:

\begin{tabular}{|c|c|c|}
  \hline
  1 & 3.1 & 6.4 \\
  2 & 3.2 & 6.45 \\
  3 & 3.1 & 6.43 \\
  4 & 3.15 & 6.4 \\
  \hline
\end{tabular}

If you want to cite a reference, you need to put in in the
bibliography file (Thesis.bib in this case) then type in something
like \cite{ferziger:2002} and the reference will appear in the text.

I have included a PDF file of a reasonably good reference manual for
LaTeX but I would also recommend the 'Guide to LaTeX' by Kopka and
Daly.
